14 60549
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
11. HEATER ASSEMBLY OR BURNER DOES NOT SHUT OFF
12. CLOTHES DO NOT DRY
POSSIBLE CAUSE TO CORRECT
Improper motor switch. Timer must be in a heat
setting.
• Test switch and replace if inoperative.
Motor does not stop. • Refer to Paragraph 4.
Incorrect wiring. • Refer to appropriate wiring diagram.
Heater assembly shorted. • Remove heater assembly and check for short.
POSSIBLE CAUSE TO CORRECT
Heater assembly does not heat or burner does not
ignite.
• Refer to Paragraph 5.
Too much water in articles being dried. • Remove excess water.
Clothes load too large. • Remove part of load. A normal washer load is a normal
dryer load. Maximum load: Dryer cylinder one half full of
wet clothes.
Excessive lint on lint filter. • Clean lint filter.
Load too small. • Add one or two bath towels to load.
Automatic cycle. • Adjust to more dry setting.
Three position heat selector switch or timer set on
FLUFF or inoperative.
• Reset switch or timer, or test and replace the switch or
timer if inoperative.
Improper or inadequate exhaust system. • Refer to Installation Instructions (supplied with dryer)
for exhaust requirements.
Heater assembly or burner shuts off prematurely. • Refer to Paragraph 9.
Gas Models: Gas line pressure too high or too low. • If natural gas line pressure to dryer exceeds 8 inch water
column pressure, or is lower than 4 inch water column, ask
gas company to correct.
Kommentare zu diesen Handbüchern